Slate Roof and Wall Profile Rollformer

Expand your business with quick and easy to install slate-effect roof and brick-effect wall profiles!

A Profiilikeskus slate-effect roof and brick-effect wall profile rollformer is a completely new innovation. The rollformer combines the traditional beauty of a slate roof with all the benefits afforded by modern steel roofing. In addition to slate-effect roofing profile, the same machine can also produce high quality brick-effect wall profiles.

Both the roof and wall profiles are quick and easy to install. No professional third-party contractors or special tools are needed. The slate-effect roof profile can be directly installed on roof trusses, rafters or battens.

Brick-effect wall profiles are installed without joint support pieces. For fast and high-quality installation, the wall is divided into convenient sections and a vertical metal trim is used in the joints.

• The rollformer can produce four different wall profile widths. Adjusting the machine for different strip widths is fast and easy. In addition, the possibility to emboss the profiles with a brick effect results in total of 8 different wall profile variations.
• The joint support pieces which are needed for the installation of slate roofing profiles are produced with this same machine. Tool change is fast and straightforward. Thanks to the feature, no other special machines or accessories are needed to deliver state-of-the-art steel profile slate roof.
• The efficient rollformer has a fully machined frame including machined stations. This results in extraordinary measurement accuracy of profiles which further ensures the perfect waterproof of profile structures produced by the rollformer.
• All the machine controls are available in one spot through an easy-to-use interface screen. Based on desired profile length, advanced software determines the right cutting point. The surface brick pattern can be altered by chancing the embossing roll.

Material Requirements

Thickness

0.7 mm

Width of strip

for slate roof profile: 416 ±1 mm
for slate roof joint support pieces: 360 ±1 mm
for wall cladding profiles: 241, 300, 366 and 416 ±1 mm

The strip widths are chosen in such a way that no waste strip is produced when using a full-width coil.

Coatings

Pre-coated sheet

Steel quality

DIN EN 10346: S220GD+Z - S320GD+Z